Loading ...
Loading ...
MODELS B5330SS • B5336SS
Page 3
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
MEASURE THE INSTALLATION
A maximum of 36” above cooktop is recommended for best
capture of cooking impurities. The bottom of the hood MUST
NOT BE LESS than 30” above the cooktop.
Distances over 36” are at the installer and users discretion;
providing that the ceiling height permits.
6"
ROUND DUCT
ROOF CAP
30" TO 36"
ABOVE COOKING SURFACE
WALL CAP
DECORATIVE
FLUE
HOOD
ROUND
ELBOW
3¼” FROM
WALL TO
DUCT
CENTERLINE
3-5/32”
WALL CAP
30” TO 36” ABOVE
COOKING SURFACE
HOOD
DECORATIVE FLUE
ROOF CAP
6” ROUND DUCT
ROUND ELBOW
13-9/16”
TO CENTER OF
BRACKET HOLES
HOOD
MOUNTING
BRACKET
PREPARE THE HOOD
Unpack hood and check contents. You should receive:
1 - Hood
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
1 - Parts Bag containing:
8 - Mounting Screws (#8 x 3/8” Pan Head)
5 - Mounting Screws (#8 x 1-1/2” Flat Head)
2 - Mounting Screws (#8 x 1-3/16” Pan Head)
5 - Drywall Anchors
2 - Washers
1 - Installation Manual
5 MOUNTING
SCREWS
(#8 X 1-1/2”
Flat Head)
5 DRYWALL
ANCHORS
8 MOUNTING
SCREWS (#8 x
3/8” Pan Head)
DECORATIVE FLUE
2 WASHERS
UPPER
FLUE MOUNTING
BRACKET
HOOD MOUNTING
BRACKET
LOWER
FLUE MOUNTING
BRACKET
DAMPER / DUCT
CONNECTOR
2 MOUNTING
SCREWS
(#8 X 1-3/16”
Pan Head)
Loading ...
Loading ...
Loading ...