Loading ...
Loading ...
Loading ...
3.Insert the new filter into the filter
holder.
4.Push the filter, and then turn it
clockwise until it locks. If you have
trouble inserting the water filter
because of high water pressure, shut
off the water supply valve.
5.If you turned off the water supply,
turn it back on.
Removing any residual matter
inside the water supply line after
installing the water filter
It is recommended to change the
water filter every 6 months.
After turning on the water supply,
you should check the leaks. If leaks
occur, repeat the steps 1- 5. If leaks
persist, discontinue use and call
Hisense customer service.
Note
1. After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from the
system.
2. Additional flushing may be required
in some households.
3. Open the refrigerator door and make
sure there are no water leaks coming
from the water filter.
Sometimes, it is hard to
disassemble the water filter
because impurities in the water
cause it to stick. If you are having
difficulties, grip the water filter
firmly and pull it out.
Note
Be sure to flush the dispenser
thoroughly, otherwise water may
drip from the dispenser. This
means that there is still air
in the line.
Do not dispense the entire 2.5
gallon amount continuously.
Depress and release the
dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
Note
24
Using your appliance
Loading ...
Loading ...
Loading ...