3 PIECE
COIL SPRING
COMPRESSOR
68614 – N151 INSTRUCTIONS FOR USE
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire. SO53 1YF. UK. DBPR0421
Helpline:
+
44
(
0
)
23 8049 4344 Sales Desk:
+
44
(
0
)
23 8049 4333 General Enquiries:
+
44
(
0
)
23 8026 6355 internet: drapertools.com email: [email protected]
HEALTH AND SAFETY INFORMATION
INSTRUCTIONS FOR USE
1. Fit the spring compressors onto the coil spring, ensuring they are opposite each
other.
2. Compress the spring evenly by tightening the hexagon headed bolts on both
compressors. This can be done using any ½" square drive driving tool or a 24mm
wrench or socket.
3. When fully compressed the shock absorber can be removed. When removing the
compressors, ensure that both clamps are slackened off evenly.
4. Maximum operating torque should not exceed 20lb-ft (27Nm) for operator safety.
IMPORTANT
Always wear safety glasses and gloves when using these compressors.
For detailed and concise instructions on the correct use of this tool, refer
to the vehicle manufacturer’s or Haynes workshop manuals.
WARNING:
When compressing springs, always ensure clamps remain correctly aligned as
pressure is applied. When releasing pressure from springs for replacement, etc.,
undo both clamps evenly 2 to 3 turns on the bolts at a time.
