Loading ...
Loading ...
Loading ...
26
ENGLISH
The following table shows the Special
Function P3 programmes, indicating
weight intervals, and defrosting and
standing times (in order to ensure the
food is of a uniform temperature).
Programm
Food
Weight (g)
Time (Min.)
Note
C 01
Pizza
300 – 550
3 – 9
Preheat the baking
pan
C 02
Deep frozen food
400 – 1000
8 – 14
Turn 2 x, keep
covered
C 03
Potato dishes, frozen
200 – 450
10 – 12
Turn 1 x
Important Note:
Always use dishes for use in the
microwave oven and a lid or cover to
avoid loss of liquids. Stir or mix the
foods several times during heating,
especially when the oven emits a beep
and the display is flashing as follows:
Warning! After heating, the
container may be very hot. Although
microwaves do not heat up most
containers, these may heat up through
heat transmission from food.
Preparation instructions:
1. Frozen pizza – Use pre-cooked
frozen pizzas and pizzas-rolls.
2. Deep-frozen food – Use lasagne,
cannelloni, prawn soufflé, all
frozen. Keep covered.
3. Potato dishes, frozen – Chips,
potato croquettes and fried
potatoes must be suitable for
preparation in the oven.
10. WHEN THE OVEN IS WORKING...
10.1. Interrupting a cooking
cycle
In both cases:
1. Microwave emission is stopped
immediately.
2. The grill is de-activated but is still
very hot. Danger of burning!
3. The timer stops and the display
shows the remaining amount of
operating time.
If you wish, at this time you can:
1. Turn or stir the food to ensure it will
be evenly cooked
2. Change the process parameters,
3. Cancel the process by pressing the
Cancel key.
4. To restart the process, close the
door and press the Start key.
10.2. Altering parameters
The operating parameters (time,
power, temperature) can be altered
when the oven is operating or when
the cooking process has been
interrupted by proceeding as follows:
1. Select the parameter to be change
with the Parameter selection keys.
The respective symbol and the
display start blinking.
2. Set the desired value with the Plus
and Minus keys.
3. Press the Confirmation key or wait
3 seconds to validate the new
parameter value. The display and
symbols stop blinking.
10.3. Cancelling a cooking cycle
If you wish to cancel the cooking
process, press the Cancel key twice.
You will then hear a beep and the time
will appear on the display.
10.4. End of a cooking cycle
At the end of the process you will hear
three beeps and the display will show
the word “End”.
The beeps are repeated every 30
seconds until the door is opened or the
Cancel key is pressed.
Loading ...
Loading ...
Loading ...