Loading ...
Loading ...
Loading ...
15OPERATING INSTRUCTIONS
8. The TIMER function enables you to either
Delay Start or Delay Stop the unit in the
choice from 0.5 hour to 24 hours. If the unit
is running, then selecting Timer will turn the
unit o in the hours that will be set (Delay
Stop). If the unit is o, then selecting Timer
will turn the unit on in the hours that will be
set (Delay Start). TIMER setting: First press
TIMER button, then adjust timer setting, by
tapping or holding the “ - ” or “ + ” button to
change the delay timer at 0.5 hour
increments, up to 10 hours, then by 1 hour
increments up to 24 hours. The control will
count down the time remaining (8h, 7.5h,
7h etc.) until the unit either starts or stops.
For the Delay Start, the fan speed and
humidity maintained will be the same as
previous setting. After TIMER setting
finishes, pressing TIMER button again at
any time will stop the TIMER function. The
Delay Start/Stop Feature will work until the
unit either starts or stops. Once that
happens the above steps have to be
repeated.
NOTE
1. Before entering TIMER setting, make sure
power is being supplied to the unit.
2. Before entering TIMER setting, select a
desired setting for operation when the
unit turn on.
4. To use Dry mode, press the Mode button to
choos Dry mode. In this mode, you can
press the HUMIDITY - or + buttons to
choose a value between 35% to 85%, so the
room is kept at a comfortable humidity.
Pressing the - or + buttons will change the
humidity selection in 5% increments. 5
seconds after you have set the desired
humidity, the readout will display the actual
room humidity.
5. During the Dry mode, You can also use the
FAN SPEED button to change the fan
speed to Hi, Med or Lo. The indicator light
will show the setting you have selected. A
higher fan speed will result in quicker
moisture removal.
6. To use CONTINUOUS mode, when in Dry
mode pressing the “ - ” button until the
display reads CO. In this mode, the unit will
continuously on and the unit will only
display CO not the room humidity. To leave
this mode, press the “ + ” button.
7. The Filter reset light will illuminate after
250 hours of operation. At this time refer to
the care and cleaning section to remove
and clean the filter. Once the filter has been
cleaned and replaced, simply press the
Filter reset button to extinguish the light.
Loading ...
Loading ...
Loading ...