Loading ...
Loading ...
Loading ...
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
Thisoven isequipped with a state of the art electronic oven controller. Among itsmanyfeatures isa full time oven circuit
diagnosticssystem.The controller constantly monitors itsinternal circuitryaswell asseveralcrucialovencircuitsto insure
they are all operating correctly. If at any time one of these systemsfails,the controller will immediately stop operation,
beeping and flashing an error code of F1 or F3* in the display window.
OCCURRENCE
Range is not level.
POSSIBLE CAUSWSOLUTION
Poorinstallation. Placeovenrack incenter of oven. Placea levelonthe oven rack.Adjust
leveling legs at base of range until the rackislevel. When range islevel, cooktop may
appear out of alignment if countertop is not level.
Weak, unstable floor. Be sure floor islevel and can adequately support range. Contact
a carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Besure cabinets
are square and have sufficient room for range clearance.
Cannot move appliance easily. Appliance Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
must be accessible for service, problem.
Contact builder or installer to make appliance accessible.
Carpeting interferes with range. Provide sufficient space so range can be lifted over
carpet.
Gas line is hard-plumbed. Have a flexible A.G.A./C.G.A. approved metal appliance
connector installed.
*Oven control beeps and displays F1 or F3. Electroniccontrol hasdetected a fault condition. PushCANCEL to clearthe displayand
stop beeping. Reprogram oven. If fault recurs, recordfault number. PushCANCEL and
contact an authorized servicer.
Surface burners do not light. Surface Control knob has not been completely turned to LITE. Pushin and turn the
Surface Control knob to LITEuntil burner ignitesand then turn control knob to desired
flame size.
Burner ports are clogged, Clean burners. See _ro Clean the Contoured Well Areas,
Burner Cap Assembly, Trim Ring (some models), Burner Pan (some models) and Burner
Base" under General Cleaning. With the burner off, clean ports with a small-gauge
wire or needle.
Range power cord is disconnected from outlet (Electric Ignition Models only). Be sure
cord is securely plugged into the outlet.
Electrical power outage (electric ignition models only). Burners can be lit manually. See
Setting Surface Controls in this Owner's Guide.
Surface burner flame burns half way Burner ports are clogged. With the burner off, clean ports byusinga small-gauge wire
around, or needle.
Moisture ispresent after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.
Surface burner flame is orange. Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
18
Loading ...
Loading ...