Loading ...
Loading ...
Loading ...
Before Setting Surface Controls
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Be sure to follow the installation instructions when
installing your new range.
2. Remove all packing tape from cooktop and burner
caps. Remove Bridge Burner Caps and Bridge
Burner Heads (See Figure 3).
3. Discard all packing material located under Bridge
Burner Heads (if applicable).
4. Replace Bridge Burner Caps. These include one
Bridge Burner Center Cap (rectangular shaped)
and the two Bridge Burner End Caps (The Bridge
Burner End Caps will fit either the front or rear 1_, "_
Bridge Burner Head locations). Make sure that the BridgeBurner Fig
tabs located under the Bridge Burner Caps fall into
the slots located in the Bridge Burner Head (See B,_ge B.....
arrows in Figure 3) and that all the Bridge Burner -B.,.er
Caps lie flat and evenly on the Bridge Burner EndCap
Head. B.dge
5. Unpack the grates and place them on the cooktop Burner B .....
- Center
as shown. NOTE: Do not force End Burner Grates cap
down on cooktop. Position Burner Grates on
cooktop and check that all the Burner Grate legs 8,_ge
- Burner
lie on the glass surface. Endcap
REMEMBER -- DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL
TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.
Regular Burner
Triple Burner Figure 4
Figure 5
iii........
....i....
Locations of the Gas Surface Burners (See
Figure 5)
The STANDARD sized burners are used for most surface
cooking needs. These burners are located at the center
rear and right rear positions on the cooktop. They can also
be used as SIMMER burners with the simmer plate to
simmering delicate aliments as chocolate, sauces, etc.
The POWER burners are best used for bringing large
quantities of liquid rapidly up to temperature or when
preparing larger quantities of food. These burners are
located at the right front and center front (when both
portions of the burner are in use) positions on the cooktop.
The BRIDGE burner is best suited when using rectangular
or long shaped cookware. The left rear and left middle are
combined and controlled by the same control knob. The left
front burner may also be added for a total of 3 burners.
Loading ...
Loading ...
Loading ...