Loading ...
Loading ...
Loading ...
32 / EN
Washng Machne / User Manual
4.7.4 Cleanng the water ntake flters
There is a filter at the end of each water intake valve at the rear of the product and also
at the end of each water intake hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the product. Filters should be
cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. RReplace the seals and filters carefully and tighten their nuts by hand ensuring there
are no leaks.
4.7.5 Dranng remanng water and cleanng the pump flter
The filter system in your product prevents solid items such as buttons, coins and fabric
fibres clogging the pump impeller during discharge of washing water. Thus, the water will
be discharged without any problem and the service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be
cleaned whenever it is clogged or every 3 months. Water must be drained off first to clean
the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water
should be drained completely.
A
CAUTION:
Foreign substances left in the pump filter may damage your product or may
cause noise problem.
CAUTION:
In regions where freezing is possible, the supply tap must be closed, system
hose must be removed and the water inside the product must be drained when the product
is not in use.
CAUTION:
After each use, turn off the water tap to which the mains hose is connected.
Loading ...
Loading ...
Loading ...