Loading ...
Loading ...
Loading ...
11
Basic Operation
depleted. When the LED turns red and an alarm sounds continuously,
it indicates the UPS system's batteries are nearly out of power and
UPS shut down is imminent.
“BATTERY WARNING” LED: this LED lights red and an alarm sounds
intermittently after you initiate a self test (See “MUTE/TEST” Button
description) to indicate the UPS batteries need to be recharged or
replaced. Allow the UPS to recharge continuously for 12 hours, and
repeat the self-test. If the LED continues to light, contact Tripp Lite
for service. If your UPS requires battery replacement, visit tripplite.com
to locate the specific Tripp Lite replacement battery for your UPS.
AC Receptacles: Your UPS features C13 outlets. These output
receptacles provide your connected equipment with AC line power
during normal operation and battery power during blackouts and
brownouts. The UPS protects equipment connected to these
receptacles against damaging surges and line noise. If you have
a serial or USB connection to your UPS, you can remotely reboot
connected equipment by turning individually controllable receptacles
OFF and ON using Tripp Lite's PowerAlert Software. Three receptacles,
labeled LOAD 1, LOAD 2 and LOAD 3, are individually controllable
and may be remotely switched OFF and ON using PowerAlert Software
without interrupting power to equipment connected to other outlets.
Outlets labeled UNSWITCHED may not be remotely turned off.
Unswitched outlets can only be turned off by turning off all output
receptacles. See software instructions for details.
Communications Ports (USB or RS-232): These ports connect
your UPS to any workstation or server. Use with Tripp Lite’s
PowerAlert Software and included cables to enable your computer
to automatically save open files and shut down equipment during a
blackout. Also use PowerAlert Software to monitor a wide variety of
AC line power and UPS operating conditions. Consult your PowerAlert
Software manual or contact Tripp Lite Customer Support for more
information. See “USB and RS-232 Serial Communications” in the
“Optional Installation” section for installation instructions.
EPO (Emergency Power Off) Port: Your UPS features a EPO port that
may be used to connect the UPS to a contact closure switch to enable
emergency inverter shutdown. See Optional Installation.
Other UPS Features (Rear Panel)
C13
21-10-011 932827-book.indb 11 10/14/2021 1:47:56 PM
Loading ...
Loading ...
Loading ...