Clore Automotive JNC770R User Manual

Loading ...

Jump Starting Instructions

Safety Check List

AlwaysPerformthisStepBeforeUsetoEnsureSafeOperation.

1. Check to make sure that the clamps and cables are in good working order. Signs

that the clamps may be damaged include, but are not limited to the following:

  -BurnMarksontheJaws

- Damaged clamp handles

- Damaged clamp springs

- Damaged cables where copper wiring may be exposed (insulation jacket

deteriorated, cut or missing)

2. Checktomakesurethecaseisnotswollen(asignofdamagedbatteries).

Verifyingthesesimplecheckpointsbeforeeveryusewillkeepyourjumpstartersafeto

use and increase its service life.

Note: For optimum performance, do not store your Jump-N-Carry below 50°F when

using as a jump starter. NEVER charge or jump start a frozen battery.

1. Useinawellventilatedarea.

2. Shieldeyes.Alwayswearprotectiveeyewearwhenworkingnearbatteries.

3. Reviewthisinstructionmanualandtheinstruction/safetymanualprovidedbythe

manufacturer of the vehicle being jump started.

4. TurnvehicleignitionoffandensureunitON/OFFswitchisintheOFFposition

before making cable connections.

5. Clamp the positive (red +) clamp to the positive terminal on the vehicle

battery (for negative ground system), or an alternate vehicle starting point as

recommended by vehicle manufacturer.

6. Clamp the negative (black –) clamp to the vehicle ground (non-moving metal part,

such as the vehicle frame).

Note: If warning buzzer beeps, do not advance to step 7. Determine source of

error. Display will show one of two error codes: Er1 – reverse polarity, Er2 – over-

voltage (connected to a battery above 16VDC). Resolve the error source before

proceeding to the next step.

7. TurnunitON/OFFswitchtoONposition.

8. Makesurethecablesarenotinthepathofmovingengineparts(belts,fans,

etc.).

9. Stay clear of batteries while jump starting.

10. Start the vehicle (turn on the vehicle ignition).

Note: if the vehicle doesn’t start within 6 seconds, let the Jump-N-Carry cool

for 3 minutes before attempting to start the vehicle again or you may damage the

Jump-N-Carry.

11.Whenthevehicleisstarted,turnON/OFFswitchtoOFFposition,disconnectthe

negative (–) battery clamp from the vehicle frame and return it to its holster.

12.Disconnectthepositive(+)clampandreturnittoitsholster.

Loading ...

Clore Automotive JNC770R Jump-N-Carry 1700 Peak Amp Premium 12 Volt Jump Starter