Clore Automotive JNC770R User Manual

Loading ...

Features

• TheJump-N-Carry provides plenty of power for starting vehicles – more than

enoughtostartmostcars,trucks,SUVsandlightdutycommercialvehicles.

• Theunitcontainsthelatesttechnologywithits12Voltsealed,non-spillable

battery and may be stored in any position.

• TheunitfeaturesamasterON/OFFswitch.TheunitshouldbekeptintheOFF

position at all times when it is not in use.

• Theunitfeaturesextra-longcablereachtoallowsafe,easypositioningwhile

jump starting. Always re-wrap cables and re-holster the clamps after each use.

• Theunitwillpowermost12Vdcaccessoriesequippedwithamale12Voltplug.

The DC outlet features automatic overload protection.

• TheunitwillprovideUSBpowertosmallelectronics,with1.1Aand2.1Aoutput

options available.

• TheunitfeaturesahighintensityLEDlighttoassistwhenjumpstartinginthe

dark or at other times when additional light is needed.

Recharging

Note: Upon initial purchase, charge your Jump-N-Carry until the display reads FUL.

Recharge the Jump-N-Carry using a household extension cord connected to the built-in

charger in the back of the unit.

1. Connect the female end of the extension cord to the charger plug on the back of

the unit. The charger plug has two blades and resembles a standard household

plugthatwouldfitintoa120Vacwallreceptacle.

2. ConnectthemaleendoftheextensioncordtotheACoutlet.

3.ChargeuntilthedispayreadsFUL.

Note: The unit can remain connected to AC power indefinitely without adverse

consequences. The charging system is fully automatic and will only consume

power as need to maintain the onboard battery.

Note: If the display shows Er3 when you connect an extension cord to charge,

the internal battery is either damaged or too discharged to accept a charge.

Battery Status Indication

Pressandholdthe“V”(VoltageStatus)Buttontoshowthebatterystatusonthedisplay.

The message seen on the display corresponds to the battery’s state of charge:

 • Ifthebattery’svoltageislessthan12.4V,thedisplaywillflashthevoltageand

thenshowCHGcontinuously,indicatingtheunitshouldbechargedimmediately.

 • Ifthebattery’svoltageisbetween12.4-12.8V,thedisplaywillshowthebattery’s

voltageandthenflashCHGthreetimes,indicatingtheunitisinneedofcharge.

 • Ifthebattery’svoltageisabove12.8V,thedisplaywillalternatelyflashthe

battery’svoltageandFUL,indicatingthattheunitisfullycharged.

Loading ...

Clore Automotive JNC770R Jump-N-Carry 1700 Peak Amp Premium 12 Volt Jump Starter