Loading ...
Loading ...
Loading ...
I Basic Connections/Auto Setup
in this section, you will connect the D VD-VCR to your television
and run Auto Setup, which automatically searches for channels and
sets the player's internal clock.
NOTES:
• Advanced Connections are covered in Appendix A.
• Even if you plan to use the S.Video or Component Video Outputs,
_y_ you MUST connect the DVD.VCR to your television with
either the standard RF or the Line Out connection. This
enables you to operate the DVD-VCR setup menus.
1 Connect Antenna/Cable to DVDoVCR
Connect the RF antenna cable from your indoor/outdoorantenna or
cable wall outlet to the IN (FROM ANT.) jack on the back panel of
the DVD-VCR.
Connect DVD-VCR to TV
Choose one of the following methods to connect the DVD-VCR to
yourIV:
RF Connection
Connect the supplied RF antenna cable from the OUT (TO TV) jack
on the back panel of the DVD-VCR to yourtelevision'sAntenna
input.
NOTE : Check the channelto connectDVD-VCR to your
television'sAntenna Input; See page 22.
Line Connection
Connect an RCA-type audio/video cable (red. white, yellow) from
the LINE OUT jacks on the back panel of the DVD-VCR to your
_elevision's Line In jacks. Use red for right audio, white for left
audio, and yellow for video.
NOTE: It is recommended that you use the Line Connection if your
TV is equipped with RCA jacks.
3
Plug In DVD-VCR
Connect the DVD-VCR power cord to a standard 120V/60Hz wall
ouUet. Don't press any buttons on the DVD-VCR or remote during
auto setup. "AUTO" blinks while the DVD-VCR runs an auto setup
procedure,where it will automatically search for all active channels
and set the clock. When Auto setting has been completed, the front
panel displays the currenttime. If Auto Clock set is unable to find a
channel to set the clock, you can set the clock manually; See page
18
4 Turn On DVD-VCR
PressthePOWERbuttonon the remotecontro_oron the
DVD-VCR'sfront panel.
5 Turn On TV
Pressthe POWERbuttonon your TV.
6
Set TV to Channel 3, 4 or Line
Be sure _ouse the same channel you selected in Step 2 If you
used the Line Connection, set your TV to its Line Input.
FromAntennaor Cable
To TV's Antenna Input
r
Loading ...
Loading ...
Loading ...