Loading ...
Loading ...
Loading ...
6
• Do not install this product on a wall if it could be exposed to oil or oil
mist. This may damage the product and cause it to fall.
• As this is a product for wall-mounted installation only, be sure to install
the product on a wall before use.
- If you use it without a wall mount, the product may tip over and
cause injury.
How to fasten anchors and screws
Wall fixing bracket fixing anchor
Wall fixing bracket fixing screw
1 Drill holes in anchor locations with a drill bit of Ø8 mm to a depth of
80mm to 100mm.
2 Clean the drilled holes.
3 Insert the enclosed wall fixing bracket fixing anchor into the hole.(Use a
hammer when inserting anchors.)
4 Attach the wall fixing bracket close to the wall, according to the hole
position. At this time, make sure that the “TOP” mark faces upwards.
5 Fit the wall fixing bracket to the hole. At this time, tighten the screws to a
torque of between 45kgf/cm to 60kgf/cm.
• Check the material of the wall and the thickness of the finishing.
• Use the Wall mount anchor for wall material of concrete, light concrete,
strong natural stone, soft natural stone masonry brick and hallow block
that do not crack.
Wall Material Tools Wall Width
Concrete
Wall fixing bracket
fixing screw, wall
fixing bracket
fixing anchor, drill
bit (Ø 3 / 6 / 8)
70mm
Brick
Natural stone
Metal Panel
Plywood
Wall mounting
bracket fixing
screw, drill bit
(Ø 1.8)
30mm
EPS Panel Penetrate the wall
Plasterboard + Plywood 30mm
• When installing on a gypsum board or medium-density fiberboard
(MDF) wall, fasten the screws to the studs that support the wall. If there
are no studs, check the distance from the inner wall before installing.
- 30mm or below: Install directly on the inner wall using a 65mm
screw.
- 30mm or above: Install using a separate hanger.
Wall
• When installing the wall mount, check the positions of the wooden studs
using a stud finder. Then, fasten the screws on at least two separate
studs before proceeding.
Wall fixing bracket
Stud
• When installing on other unspecified walls, install it so that it can
withstand a pull-out load of 70 kgf (686 N) and a shear load of 100 kgf
(980 N) or more per fixed part.
• Use the Ø8mm drill bit for concrete and hammer (Impact) drill.
Antenna/Cable
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
• Use a signal splitter to use more than 2 TVs.
• If the image quality is poor, install a signal amplifier properly to improve
the image quality.
• If the image quality is poor with an antenna connected, try to realign the
antenna in the correct direction.
• An antenna cable and converter are not supplied.
• For a location that is not supported with Ultra HD broadcasting, this TV
cannot receive Ultra HD broadcasts directly.
Satellite dish
Connect the TV to a satellite dish to a satellite socket with a satellite RF cable
(75Ω). (Depending on model)
Loading ...
Loading ...
Loading ...