Loading ...
Loading ...
Loading ...
USA-CAN - 28
machine by pressing Start/Pause key as
soon as the door of the machine is opened.
In other situation, the machine will stop
automatically after 4 seconds when the
door of the machine is opened and any key
is not pressed. To start a program, Start/
Pause key is pressed and close the door of
the machine within 4 seconds.
iii. If the door is opened while the machine
is running, the machine will switch to the
standby mode. Press Start/Pause key and
close the machine door within 4 seconds,
then the program will resume.
8.7. Child (Key) Lock
Not available.
8.8. Cancelling The Program
1. Press program Selection + Cancel key
for 3 seconds to cancel the program.
2. After 3 seconds, “1” will appear on
the display. For a couple of minutes the
machine will fulfill the necessary operations
required to cancel the program.
i. There might be residues of detergent or
rinse aid left in the machine and/or on the
pieces being washed depending on the step
the program you have cancelled was in.
8.9. Salt Indicator (Model Depending)
Please check the salt indicator on the
control panel to see whether there is
adequate amount of softening salt in the
dishwasher or not. You need to refill the salt
reservoir with salt whenever salt warning
indicator appears on the control panel of
your machine.
8.10. Rinse Aid Indicator
Please check the rinse aid indicator
on the control panel to see whether there
is adequate amount of rinse aid in the
dishwasher or not. You need to refill the
rinse aid reservoir with rinse aid whenever
rinse aid warning indicator appears on the
control panel of your machine.
8.11. End of Program
“00” will be displayed when the washing
programme is over.
1. Open the door of the machine.
2. Press Start/Pause + On/Off key to turn
off your machine.
3. Close the tap.
4. Unplug the machine from the socket.
i. Leave your dishes in the machine for
about 15 minutes to cool down after they
are washed. Your dishes will dry in a shorter
time if you leave the door of your machine
ajar during this period. This process will
increase the drying effectiveness of your
machine.
8.12. Water Cut - Off Warning
If mains water is cut or water inlet tap is
turned off the machine can not take water
in and “FF” will flash continuously on the
display. As long as the problem continues,
the washing program is stopped and water
inlet is checked regularly by the user. If the
water inlet is provided, the machine gets
ready to start a new program.
8.13. Overflowing Warning
If the machine intakes too much water or
there is leakage at any of the compo-nents
then the machine will detect this and “F1”
will flash on the display. As long as the
overflowing continues, safety algorithm will
be active and try to discharge the water. If
overflowing stops and safety is assured,
“F1” will disappear. If “F1” does not
disappear,
there is a permanent fault. In this case, the
authorized service should be contacted.
Loading ...
Loading ...
Loading ...