Loading ...
Loading ...
Loading ...
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractorall parts and hardware you assemble mustbe tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set willmake assembly easier. Standard
wrench sizes are listed.
(1) 3/4" Socket w/drive rachet Utility knife
(2) 7116"wrenches Tire pressure gauge
(2) 1/2=wrenches
(1) 9116"wrench
When dght or left hand is mentioned in this manual, it
means when you are in the operating position (seated
behind the steering wheel).
TO REMOVETRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton (See page 5).
• Cut, from top to bottom, along lines on all four comers
of carton, and lay panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE ROLUNG TRACTOR OFF SKID
A'I-rACH STEERING WHEEL (See Fig. 1)
PREASSEMBLE SLEEVE TO STEERING WHEEL (See
Fig. 1 Inset)
Install sleeve retainer clips, evenly spaced around
steering wheel hub, with formed tabs toward the out-
side of hub.
• Press or lightly tap retainer clips fully onto steering
wheel hub.
Press stee ring sleeve fully onto steedng wheel hub and
clips.
ASSEMBLE EXTENSION SHAFT
Slide extension shaft onto lower steering shaft. Align
mounting holes in extension and lower shalts and
install5/16 hex bolt and Iocknut. Tighten securely.
IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO
18-22 FT. LBS TORQUE.
INSTALL STEERING WHEEL
Position front wheels ofthe tractor so they are pointing
straight forward.
Slide steering wheel adapter onto steering shaft exten-
sion.
Position steering wheel and sleeve assembly so cross
bars are horizontal (left to right) and slide onto adapter.
Assemble large flat washer, 3/8 lock washer, 3/8 hex
bolt and tighten securely.
Snap steering wheel insert into center of steering
wheel.
Remove protective plastic from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID,
STEERING ""-.-_./,
WHEEL 1
_' i "_,""-INSERT
3/8 HEX BOLT
3/8 LOCK WASHER
@1:------_ LARGE FLAT
WASHER
,/
J
;TEERING
SLEEVE
ADAPTER
I EXTENSION SHAFT
5/16 HEX BOLT
6
FIG. 1
TO ROLL TRACTOR OFF SKID (See Opera-
tion section for location and function of con-
trols)
Press liftlever plunger and raise attachment liftlever t¢
its highest position.
• Release parking brake by depressing ciutch/brak_
pedal.
• Place gearshift lever in neutral (N) position.
• Roll tractor backwards off skid.
• Remove banding holding discharge guard up agains
tractor.
CONNECT BATTERY (See Figs. 2 and 3)
&
CAUTION: Do not short battery termi-
nals. Before connecting battery, re-
move metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
Loading ...
Loading ...
Loading ...