Troy-Bilt 13AT609G766-2003 Troybilt lawn tractor

User Manual - Page 17

For 13AT609G766-2003.

PDF File Manual, 40 pages, Download pdf file

Loading ...
Loading ...
Loading ...
5. Threadhosecoupler(packagedwiththismanual)onto
theendofyourgardenhose.SeeFigure12.
6. Attachthehosecouplertothewaterportonyourdecks
surface.SeeFigure12.Turnthewateron.
7. Whilesittingintheoperator'sposition,re-startthe
engineandplacethrottleleverinFAST(rabbit)
position.
8. MovethePTO(BladeEngage)LevertoONposition.
9. Remainintheoperator'spositionwiththecutting
deckengagedforaminimumoftwominutes,allowing
theundersideofthecuttingdecktothroughlyrinse.
10.MovethePTOleverallthewaybackintothe"Blade
Stop"position.
11.TurntheignitionkeytotheSTOPpositiontoturnthe
tractor'sengineoff.
12.Turnthewateroffanddetachthehosecouplerfromthe
waterportonyourdeckssurface.
WaterPort
Figure 12
Hose Coupler
(Shown without
Hose Attached)
SECTION7: SERVICE
,1_ WARNING: Before servicing, repairing, or inspecting,always disengage PTO, move shift lever into
neutral position, set parking brake, stop engine and remove key from tractor to prevent unintended starting.
IMPORTANT: Never exceed the maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires.
Refer to the tire sidewall for exact tire manufacturer's recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow unevenly.
The battery issealed and maintenance-free. Acid levels
cannot be checked. However, some care is required for
long battery life:
Always keep the battery cables and terminals clean
and free of corrosive build-up.
After cleaning the battery and terminals, apply a
light coat of petroleum jelly or grease to both
terminals
Always keep the rubber boot positioned over the
positive terminal to prevent shorting.
IMPORTANT: If removing the battery, disconnect the
negative (black) wire from its terminal first, followed by
the positive (red) wire. When re-installing the battery,
always connect the positive (red) wire to its terminal first,
followed by negative (black) wire.
Charging
If the tractor has not been used for an extended
period of time, use a voltmeter or load tester to
measure the charge. The voltmeter should read
17
Loading ...
Loading ...
Loading ...