Loading ...
Loading ...
Loading ...
PivotPoints& Linkage
Lubricate all pivot points on the drive system, parking brake and lift linkage at least once a season with light oil.
RearWheels
Remove rear wheels from the axles once a season; lubricate the axles and rims with an all-purpose automotive
grease and re-install the wheels
FrontWheels
Each front wheel axle is equipped with a grease fitting; lubricate with a grease gun after every 25 hours of
tractor operation or at least once a season.
Refer to the engine manual for engine maintenance instructions.
Check engine oil level before each use as instructed in the engine manual. Read and follow instructions
carefully. Refer to this manual for details about type and grade of oil.
ChangingEngine0il oiz FillCap ProtectiveCap
1. Unscrew oil fill cap and remove dipstickfrom the oilfill
tube. See Figure 11.
2. Pop open the protective cap on the end of the oildrain
valve to expose the oil drain port. See Figure 11.
3. Push the oil drain hose (packed with this manual) onto
the oil drain port. Route the opposite end ofthe hose
intoan appropriate oilcollection container with a
capacity great enough to collectthe used oil
(approximately 62 oz.).
4. Push the oil drain valve in slightly, then rotate
counterclockwise and pull outward to begin draining oil.
See Figure 11. Oil Fill Tube
5. Service the oilfilter as instructedin the engine manual
6. Perform the above steps in the opposite order after oil
has finished draining. Refill the engine with
approximately 62 oz.(1.8 liters) of new motor oil.
Air Cleaner
Service the pre-cleaner, if so equipped, and cartridge as
instructed in the engine manual at the end of this manual.
SparkPlug
Clean the spark plug and reset its gap once a season, preferably at the start of each mowing season. Refer to the
engine manualfor correct plug type and gap specifications.
Oil Drain Valve
Oil Drain Port
Figure 11
C eaningTheEngine& Deck
Wipe off any fuel or oil spillage on the machine promptly. Do not allow gross, leaves, and dirt to accumulate
around the cooling fins or on any other part of the machine, especially the pulleys and other moving parts.
IMPORTANT: The use of a pressure washer to clean your tractor is not recommended. Direct water pressure on
electrical components and the engine could reduce life of the tractor and its serviceability.
DeckWashSystemTM (if equipped)
Use the Deck Wash System TM to rinse grass clippings from the deck's underside and prevent the buildup of
corrosive chemicals. Complete the following steps after each mowing:
IMPORTANT: Make certain the tractor's discharge chute is directed away from your house, garage, parked cars, etc.
1. Drive the tractor to a level, clear spot on your lawn, near enough to a water sillcock (spigot) for your garden hose
to reach.
2. Move PTO lever to "Blades Stop" position.
3. Move shift lever into neutral position.
4. Set the parking brake and stop engine.
16
Loading ...
Loading ...
Loading ...