Loading ...
Loading ...
Loading ...
15
ENERGY SAVING TIPS
The appliance should be located in the coolest
area of the room, away from heat producing
appliances, and out of the direct sunlight.
Ensure that the unit is adequately ventilated.
Never cover air vents. Clean dust and dirt from
the condenser at regular intervals.
Only open the door for as long as necessary and
for as short a time as possible.
Store the content in an organised way.
Do not over-fill the appliance to allow air to
circulate.
PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling customer service.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
REMEDY
Appliance does not
operate.
Appliance is not connected to a power supply.
The appliance is turned off.
The circuit breaker tripped or a blown fuse.
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or
replace fuse.
Appliance is not
cold enough.
The temperature is not set correctly.
The ambient temperature could require a
higher temperature setting.
The door was opened too often.
The door was not closed completely.
Door is not hermetically-sealed.
The condenser is too dirty.
The ventilation opening is blocked or too dusty.
Check the set temperature.
Set a higher temperature.
Do not open the door more
often than necessary.
Close door properly.
Check the door seal and clean
or replace.
Clean the condenser when
necessary.
Clear the obstructions and
clean the dust.
Appliance turns
itself on and off
frequently.
The room temperature is higher than average.
A large amount of bottles has been added to
the unit.
The door is open too often.
The door is not closed completely.
The door gasket does not seal properly.
Put the appliance in a cooler
place.
Leave the appliance to work
for a while until the set
temperature has been
reached.
Do not open the door more
often than necessary.
Close door properly.
Check the door seal and clean
or replace.
The light does not
work.
Appliance is not connected to a power supply.
The circuit breaker tripped or a blown fuse.
The light was switched off on the control panel.
Connect the appliance.
Switch on circuit breaker or
replace fuse.
Switch on the light.
Vibrations.
The appliance is not properly level.
Level the appliance with the
adjustable feet.
The appliance
seems to make too
much noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and cracking noises.
The appliance is not properly level.
Level the appliance with the
Loading ...