Loading ...
Loading ...
Loading ...
3. Remove the drive disc (B) from the output shaft.
(Fig. 37)
To attach the cutting attachment guard
1. Attach the cutting attachment guard (A) to the hook
on the plate holder (B). (Fig. 38)
2. Install the cutting attachment guard on the shaft and
tighten it with the bolt (C).
To remove the cutting attachment guard
• Loosen the bolt (C) and remove the cutting
attachment guard (A) from the shaft. (Fig. 39)
To attach the grass blade
1. Put the gear of the product on a flat surface to make
sure that the blade is assembled correctly.
2. Turn the output shaft to align one of the holes in
the drive disc (B) with the related hole in the gear
housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft. (Fig. 40)
5. Make sure that the drive disc and support flange
engages correctly in the center hole of the grass
blade. (Fig. 30)
6. Attach the nut (G).
7. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm. (Fig. 41)
To remove the grass blade
1. Put the gear of the product on a flat surface to make
sure that the blade is removed correctly.
2. Put the locking pin (C) into the hole on the shaft to
lock the shaft.
3. Remove the nut (G).
4. Remove the support flange (F), the support cup (E)
and the grass blade (D) from the output shaft. (Fig.
40)
To adjust the harness
WARNING: Always attach this product
to the harness correctly. If not, you cannot
control the product safely and this can result
in injury to you or others. Do not use a
harness with a damaged quick release.
WARNING: Use the harness quick
release function if you must release from the
product and the harness in an emergency
situation.
1. Put on the harness.
2. Adjust the harness for the best work position.
3. Adjust the side straps until the weight is equally
applied across your shoulders. (Fig. 42)
4. Adjust the harness until the cutting attachment is
parallel to the ground. (Fig. 43)
5. If the operation is to cut grass, let the cutting
attachment stay lightly on the ground. Adjust the
suspension point to balance the product correctly.
Operation
Introduction
WARNING: Read and understand the
safety chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 44)
CAUTION: If the battery does not
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
To do before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles as stones, branches or
ditches.
• Do an overhaul of the product.
• Do the safety inspections, maintenance and service
that are given in this manual.
• If blade is used, make sure that the locknut is
tightened correctly.
1859 - 005 - 21.09.2023 17
Loading ...
Loading ...
Loading ...