Loading ...
Loading ...
Loading ...
30
REMOTE CONTROL OPERATION
OPERATIONAL NOTES:
REMOTE RECEIVER
IMPORTANT
The Thermo Feature on the transmitter operates the appliance whenever the ROOM TEMPERATURE varies a certain number
of degrees from the SET TEMPERATURE. This variation is called the “SWING” or TEMPERATURE DIFFERENTIAL. The
normal operating cycle of an appliance may be 2-4 times per hour depending on how well the room or home is insulated from
the cold or drafts. The factory setting for the “swing number” is 2. This represents a temperature variation of +/- 2ºF (1ºC)
between SET temperature and ROOM temperature, which determines when the replace will be activated.
The transmitter has ON and OFF manual functions that are activated by pressing either button on the face of the transmitter.
When a button on the transmitter is pressed the word ON or OFF will appear on the LCD screen to show while the signal is
being sent. Upon initial use, there may be a delay of three seconds before the remote receiver will respond to the transmitter.
This is part of the system's design.
POWER SETTING – GH03-R
The electronics in the remote control system have the capability of "powering" two different types of DC-powered components.
If any operational problems are noted, contact Customer Service.
The RECEIVER comes from the factory programmed to provide pulse DC voltage (5.5 VDC to 6.3 VDC) to a latching solenoid.
The remote receiver (right) operates on (4) 1.5V AA-size batteries. It is
recommended that ALKALINE batteries be used for longer battery life and
maximum microprocessor performance. IMPORTANT: New or fully charged
batteries are essential to proper operation of the remote receiver as a latching
solenoid power consumption is substantially higher than standard remote
control systems. Re-chargeable batteries should not be used.
NOTE: The remote receiver will only respond to the transmitter when the
3-position slide button on the remote receiver is in the REMOTE position. The
remote receiver houses the microprocessor that responds to commands from
the transmitter to control system operation.
THERMO ON THERMO OFF
release the SET key. The LCD screen will display the set temperature
for 3 seconds and the LCD screen will ash the set temperature
for 3 seconds, then the LCD screen will default to display the room
temperature.
TO CHANGE THE SET TEMPERATURE
Press and hold the SET key until the desired set temperature is
reached. (By pressing and holding the set key the LCD screen set
numbers will increase from 45º to 99º then restart over at 45º). Next
release the SET key. The LCD screen will display the set temperature
for 3 seconds, then will ash the set temperature for 3 seconds, then
the LCD screen will default to display the room temperature.
Press the MODE key to disengage the thermo mode. The word
ROOM on the LCD screen will not show when the thermo is not in
operation.
NOTE: The highest SET temperature is 99º Fahrenheit (32ºCelsius)
and the lowest temperature is 45º Fahrenheit (6ºCelsius).
THE REMOTE RECEIVER SHOULD BE POSITIONED WHERE
AMBIENT TEMPERATURES DO NOT EXCEED 130°F.
LEARN
Battery cover slides on/off
ON
REMOTE
OFF
Remote Receiver
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Slide
Switch
REMOTE ONOFF
Loading ...
Loading ...
Loading ...