Loading ...
Loading ...
Loading ...
Care and Cleaning
kdvar_tium Over_
Cooktop light/
night light
.To replace the cooktop light/
night light, first disconnect the
power at the main fllse or circuit
breaker panel.
.Remove the screws from the
side of the light compartment
cover and lower the cover until
it stops.
.Be sure the bulb (s) to be replaced
are cool before removing. Break
the adhesive seal by gently
unscrewing the bulb (s).
R@lace with 40-watt (max.) incandescent
bulbs. Order WBO2X4253J_}'om your GE
supplier. High-intensity 40-watt bulbs
(40S1 IN/I), availab# in supermarkets
and hardware stores, may also be used Jot
_rwplacemen ts.
4. Raise the light cover and replace
the screws. Connect electrical
power to the oven.
ReTqlo_e s(rcws
Reusable vent
filters
The metal filters trap grease released
by foods on the cooktop. They also
prevent flames fiom foods on the
cooktop fiom damaging the inside
of the oven.
For this reason, the filters must
always be in place when the hood is
used. The vent filters should be
cleaned once a month, or as needed.
Removing and
cleaning the
filters
To remove, slide them to the side
using the tabs. Pull down and out.
To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don't use ammonia
or ammonia products because they
will darken the metal. Light brushing
can be used to remove embedded
dirt.
Rinse, shake and let diy befiwe
replacing.
To replace, slide the filters into the
flame slots on the side of each
opening. Press up and to the side
to lock into place.
I! I i'
39
Loading ...
Loading ...
Loading ...