Loading ...
Loading ...
Loading ...
5
MOUNTING AND INSTALLATION
The diagram below shows a typical
mounting procedure into a fiberglass
panel. Always follow proper safety
procedures. Wear eye-protection
at all times with a dust mask and
gloves when cutting. A mounting
template is included to aid in
measuring and marking the mounting
surface before cutting or drilling.
1. Press along the perforation to
remove the center section of the
mounting template. (Discard the
center section.) The template can
be used to verify there is sufficient
flat surface area for mounting
and as a guide for cutting the
opening. Tape the template
to the mounting location and
mark the surface for cutting the
opening and drilling pilot holes.
2. Use a jigsaw or rotary tool to cut an
opening in the mounting surface.
If necessary, use a file or sandpaper
to adjust the opening for proper
fitment and smooth the edges.
3. Place the MM50 into the opening
and check that the mounting
holes remain aligned with the
pilot hole marks taken from
the template. If not, adjust and
mark new holes as necessary.
4. Remove the MM50 and drill four
(4) pilot holes in the mounting
surface at the pilot hole marks.
5. Peel the adhesive backing
from the mounting gasket and
affix to the rear of the bezel.
Connect all wiring and place
the MM50 into the opening.
6. Secure the MM50 using the four
(4) mounting screws. Press the trim
ring onto the front of the MM50.
Before drilling or cutting, make
sure there is adequate space behind
the mounting surface to fit the MM50,
including its
wire harness.
Loading ...
Loading ...
Loading ...