Loading ...
Loading ...
Loading ...
11
Rev.13052022
MOUNTING THE DOOR PANEL TO THE APPLIANCE
Ensure that there is a gap of 3–4 mm between the non-hinge side of the appliance and the vertical cabinet wall.
Mount the door panel onto the appliance door using the screw thread ad a xing guide.
Screw the bracket back onto to the appliance and use the hex nut to secure and level.
Locate the slider in the bracket and x the slider to the fascia door 20–22 mm from the edge of the fascia as shown in Fig. 5.
Ensuring that the slider is positioned sensually and horizontally within the bracket. Allow for some horizontal movement of the
cabinet door/s. Once you are happy with the alignment of each door, tighten securely by hand then use a spanner to x into
position.
Once you are happy with the alignment and have checked that the door closes and seals properly, x the remaining vertical
brackets provided to the appliance door and decor panel using wood screws
Fit all remaining covers to the appliance, concealing any screw holes and bracket bolts.
Fill the gap on the non-hinged side with the gasket/seal strip provided, as shown in Fig. 6.
Ensure the appliance door opens correctly, closes and seals properly.
Once complete, and you are happy with the t of the appliance in the cabinet, bend and snap the ’T’ parts of the white spaces at
the bottom of the appliance marked S as shown by the dotted outline in Fig. 7.
Leave the rest of the spacer cover in place over the metal plates
Install the ventilation grill at the kick panel void section at the appliance base cabinet. Fix the ventilation grill into the kick strip. Fig. 8.
Fixed screwFixed screw
Further xing
Depth adjustment
W
Cabinet door
W
Fig.18 Adjusting bottom of cabinet door
Fig.5
Fig. 7Fig. 6
Fig. 8
Loading ...
Loading ...
Loading ...