Loading ...
Loading ...
Loading ...
10
Rev.13052022
ATTACHING THE DOOR PANEL
Close the appliance door and measure from the top of the cabinet cavity to the bottom of the door bracket on both sides
ensuring that the distance is the same. You will need to know this measurement when pre-drilling the xing points in the
decor panel.
Remove the bracket by loosening the hexagonal screws located at the top of the door. Fig.2 Lift the bracket it upwards and it
should come free. Do the same for all doors. Be careful to not bend the bracket.
MOUNTING BRACKET TO THE CABINET DOOR/S
Place the each cabinet door (face down) onto a clean oor or large blanket so it does not get damaged.
Fix the panel bracket to the top of each cabinet door. Measure and adjust to ensure the centre line at the top bracket aligns with
the centre of the decor door. The alignment guides should latch onto the top of the cabinet door.
Using the measurements taken whilst the mounting bracket was xed to the door panel, mark the decor panel on each side and
draw a vertical guide line across the panel. This will show you where to place the base of the bracket. Fig. 4
Then, measure the centre point so you have a denite drill guide for the bracket screws. Use a ‘set square’ to draw these guides.
Once aligned, pre-drill the holes then place the bracket over the guides and screw wood screws to attach the decor bracket to
the cabinet door. Screw into any other xing holes (there should be 10). Fig. 4
Backside of
Upper cabinet door Lower cabinet door
Backside of
Centre line Centre line
Top of kitchen cabinet
Top of the appliance
Refrigerator door
Top attachment bracket
(disassembled status)
Fig.3
Top of kitchen cabinet
Top of the appliance
Refrigerator door
Top attachment bracket
(disassembled status)
Fig.2
Fig. 4
Loading ...
Loading ...
Loading ...