Kenmore 9119382192 Official Electric Freestanding Range

User Manual - Page 19

For 9119382192.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
RE OV ,IBLE I I OBS
The control knobs may be removed for easy cleaning by
pulling the knob straig ht off stem. Be sure that the knob
is in the OFF position before removal.
Hint: Slip a thin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up,
Caution: Read these instructions carefully be-
fore replacing the knobs. Replacing the knobs
improperly win damage the knobs and the spring
clip on the stems, 8f this happens, the knobs will
fit loosely.
To replace the knob:
1. The knob stem has a groove in each side. The groove
on one side has a spring clip. The other groove is
clear (see illustration).
MOLDED
RIB
SPRING
CLIP
2. Check the inside of the knob and find the molded rib.
3. Replace the knob by fitting the molded rib inside the
knob into the clear groove on the stem.
REMOVABLE COOKTOP UNITS
The cooktop elements can be unplugged and the bowls
removed for cleaning.
Be sure all cooktop unit control knobs are turned
off and elements are coo! before you remove or
replace a cooktop unit.
To remove:
1. Grasp element, tilt it upward slightly to clear the
bowl, then pull away from the receptacle. The element
will not sit level when replaced if it is forced too far
upward when removed.
2. For models with porcelain enameled reflector bowls,
remove the chrome trim ring. See the Cleaning
Section about information on cleaning porcelain
enameled reflector bowls.
3. Lift out the bowl.
Do not put the element into water_ it cleans itself when
heated during normal use.
When removing, do not lifta plug-in unit more than 1". Ifyou
do, itmay not lie flat on the drip pan when you plug it back in.
Repeated lifting of the plug-in unit morethan 1"abovetheddp
pan can permanently damage the receptacle.
I[_PORTANT: Never operate a cooktop element
without the bowi in place, This can cause
scorching of the cooktop, burning ol wiring insu.
lation and loss of energy.
ELEMENTS
REFLECTOR BOWLS
RECEPTACLE
To replace:
1, Replace the bowl. Be sure the receptacle is showing
in the bowl opening,
2. For models with porcelain enameled reflector bowls,
replace chrome trim ring,
3. Slidetheplug ofthe element firmly intothe receptacle
and lower the element into place,
R =PL ,CING THE OVEN UGHT
Be sure that the light switch is in the off position.
Do not touch hot oven bulb. Do not touch oven
bulb with wet l_ands. Do not wipe oven light area
with wet cloth.
Never touch the electrically live collar on the
bulb when replacing it=
Electrical power must be shut off if you have to
replace a broken bulb.
1 Unscrew glass cover and remove,
2 Replace the bulb with a 40 watt appliance bulbo
3 Replacethe cover.
Note: We recommend you use a 40 watt appliance bulb
that is no longer than 3 1/2",
18
GLASS
RETAINER
COVER
NEMNT49-1
Loading ...
Loading ...
Loading ...