Frigidaire FRS26ZSHB2 Official Refrigerator

User Manual - Page 3

For FRS26ZSHB2.

PDF File Manual, 21 pages, Read Online | Download pdf file

FRS26ZSHB2 photo
Loading ...
Loading ...
Important Safety
Instructions (continued)
[:,'*'/-'_",'_'_ Other Precautions
Never unplug the refrigerator by pulling on the power cord. Always grip the plug
firmly, and pull straight out from the receptacle.
To avoid electrical shock, unplug the refrigerator before cleaning and before
replacing a light bulb. NOTE: Turning the control to OFFturns off the compressor,
but does not disconnect power to the light bulb or other electrical components.
Do not operate the refrigerator in the presence of explosive fumes.
Avoid contact with any moving parts of the automatic ice maker.
First Steps
Roller Adjusting Bok
Adjusting Front Rollers
Replacing Toe Grille
This Owner's Guide provides specific operating instructions for your model. Use
refrigerator only asinstructed in this Owner's Guide. Before starting refrigerator,
follow these important first steps:
Location
Installrefrigerator:
nearagrounded electricaloutlet. DONOT usean extensioncord or an adapterplug.
out of direct sunlight and away from range, dishwasher, or other heat sources,
if possible.
on a floor that islevel and strong enough to support a fully loaded refrigerator.
where a water supply is available for automatic ice maker.
Installation
Do not install refrigerator where temperature will drop below 60°F (15°C), or rise
above 110°F (43°C). Compressorwill not beableto maintain proper temperatures.
In a recessed installation, allow an extra 1/2 inch (10-15 mm) on each side for
easeof installation.
If the hinge side of the unit will be placed against a wall, allowa 1-3/4 inch (44
mm) space between wall and refrigerator to permit proper door swing.
Door Opening
Forbest useof drawers and freezer basket, refrigerator should be in a position where
both the refrigerator and freezer doors can be opened about 135 °.
Leveling
Refrigerator must be leveledwith allbottom corners resting firmly on asolid floor.
Adjust front rollers to level cabinet both front-to-rear and side-to-side. Keep
cabinet aslow aspossiblefor stability. Neverac_ustcabinetrollerssofrontislower
than rear.
To adjust front rollers: Open refrigerator and freezer doors. Removetoe grille
by pulling itstraight out. AdJustrollers byturning eachroller adjusting bolt with an
adjustable wrench, a socket wrench, or a nutdriver until refrigerator islevel and
stable. Rearrollers are not adjustable.
Check both doors to be sure sealstouch cabinet evenly on all four sides.
If freezer door ishigher than refrigerator door, raiseright corner and/or lower left
corner until doors align acrosstop of cabinet.
If refrigerator door ishigher than freezer door, raiseleft corner and/or lower right
corner until doors align acrosstop of cabinet.
To replace toe grille: Line up tabs with holes, and push grille straight on.
Cleaning
Wash the inside, all removable parts, and the outside with mild detergent and
warm water. Wipe dry. Do Not Use Harsh Cleaners On These Surfaces.
Do not use razor blades or other sharp instruments that can scratch appliance
surface, when removing adhesive labels. Any glue left from the tape or energy
label can be removed with a mixture of warm water and mild detergent, or touch
glue with sticky side of tape already removed.
Do Not Remove Serial Plate.
Loading ...
Loading ...
Loading ...