Loading ...
Loading ...
Loading ...
Problem Possible Causes Solutions
Oven portion of Gas regulator shut-off valve Be sure gas regulator valve is set to the ON position. See
appliance does not may have been moved to OFF installation instructions.
operate. Gas at installation.
cooktop burners Incorrect oven control Be sure the oven control was set correctly for the requested
operate.
setting, feature. See Setting Oven Controls section and review
instructions for the desired cooking function in this manual or
see "Entire appliance does not operate" in this checklist.
Entire appliance Power supply to appliance Be sure appliance power cord is plugged properly to electrical
does not operate, disconnected or electrical outlet. Check house circuit breaker; reset if needed. If the
power outage, electric service to the house is out, call your local electric utility
for service.
Service wiring is incomplete. Contact your dealer, installing agent or authorized service agent
for assistance.
Range is not level. Floor is not level, weak or If floor under range is sagging or sloping, contact a carpenter to
unstable, correct the problem.
The cooktop or oven racks To correct, place oven rack in center of oven. Place a bubble
are not level, level centered on the oven rack. Adjust by turning leveling legs
at bottom of range until the oven rack rests level.
Cabinet alignment may make Be sure kitchen cabinets are square and have sufficient room for
range appear not level, appliance clearance.
Cannot move Gas line is hard-plumbed. Replace gas supply line with a flexible CSA International
appliance easily, approved metal appliance connector.
Appliance must be Carpet interferes with range. Provide sufficient space so appliance may be lifted over carpet.
accessible for
service. Cabinets are built in too Contact builder or installer to make appliance accessible.
tightly to appliance sides.
Convect fan makes The convect fan may turn ON This is normal. On some cooking features the convect fan may
noise (some models), or OFF automatically, run until the feature is done or the oven door is opened.
Convect fan does not
start immeadiately or
turns ON and OFF
while cooking (some
models).
Convect fan turns on The convect fan may turn ON
with features that while preheating.
should run without a
fan (some models).
Oven control displays
"Prob ERR". The
probe is not
recognized by the
oven control.
The convect fan start time is This is normal. The convect fan will take 6 minutes to begin
delayed, rotating after starting any convect feature.
Oven door is open. The convect fan will turn OFF if the oven door is opened while
any convect feature is active. Close oven door.
This is normal (on some models).
The probe is not fully inserted
into the probe receptacle.
Double check that the temp probe is fully inserted into probe
receptacle. Use only the probe originally supplied with range.
If the error code persists, the Remove the probe from receptacle and oven. The oven may
probe may be damaged or still be used normally without the probe. Call your authorized
the probe cable has a short, service agent.
37
Loading ...
Loading ...
Loading ...