Loading ...
Loading ...
Loading ...
24 Operation
Switching input signal
The projector can be connected to multiple devices at the same
time. However, it can only display one full screen at a time. When
starting up, the projector automatically searches for the available
signals.
Be sure the Advanced Menu - System > Display > Auto
Source Search menu is On if you want the projector to
automatically search for the signals.
To select the source:
1. Press SOURCE. A source selection bar appears.
2. Press / / / until your desired signal is selected and press OK.
Once detected, the selected source information will appear at the corner of the screen for seconds.
If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector’s native
resolution. Any other resolutions will be scaled by the projector depending upon the "aspect ratio" setting, which
may cause some image distortion or loss of picture clarity. See High Altitude Mode on page 36.
Loading ...
Loading ...
Loading ...