Loading ...
Loading ...
Loading ...
Run the snow thrower for a few minutes to melt away any
snow on the snow thrower.
Remove the battery pack from the snow thrower.
Examine the snow thrower thoroughly for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. To repair or replace parts, contact
our customer service help line at 1-800-633-1501.
Store the snow thrower, along with the removed battery
pack, in a clean, dry place out of reach of children. Cover
loosely with a tarp for added protection.
STORAGE
BATTERY DISPOSAL
Remove the battery pack from the snow thrower. Cover the terminals with heavy duty adhesive tape. Do not attempt to destroy or disassemble battery
pack or remove any components. This product contains lithium-ion batteries which must be recycled or disposed of properly. Local, state or federal
laws may prohibit disposal of these batteries in ordinary trash.
The RBRC seal on the li-ion battery pack indicates that the costs to recycle the battery pack at the end of its useful life has already been
paid by The Great States Corporation American Lawn Mower Company. It is illegal to place spent li-ion batteries in the local municipal
solid waste or in the trash. RBRC in cooperation with The Great States Corporation American Lawn Mower Company has provided an
environmentally friendly and easy way to recycle spent li-ion batteries. Just contact your local recycling center or call 1-800-8BATTERY
for information on where to drop off the spent battery.
CHARGING THE BATTERY PACK
SLEEP MODE:
If the light indicator button is continuously pressed for
more than 30 seconds, the lights will go into sleep mode.
When light indicator button is pushed, no lights illuminate
(This can occasionally occur during transportation).
To re-activate battery LED lights, place the battery on the
charger and charge for one to two minutes. Battery
indicator will function normally.
14
Model SN74016
Problem Possible causes Remedy
Motor does not start Battery not making contact.
Lock off not fully operated.
Battery not installed properly.
Battery not charged.
Check battery is fully inserted.
Check that lock off button is fully depressed prior to
moving trigger.
Check battery installation.
Check battery charging requirements.
Poor results Drive belt worn or damaged.
Auger worn or damaged.
Discharge blocked.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Switch off the snow thrower, remove the battery
pack, and clean the discharge.
Abnormal vibrations Drive belt worn or damaged.
Auger worn or damaged.
Scraper blade worn or damaged.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Replace the scraper blade. Ensure the screws are
properly tightened.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...