Loading ...
Loading ...
Loading ...
8
Installation Instructions
Parts List
Remove all packing materials and parts. Inspect to make sure all parts listed below are
present and in good condition:
1 double draft arm assembly (with washer)
1 CO
2 or
Nitrogen cylinder
1 CO
2
or
Nitrogen regulator
2 keg taps (American Sankey type)
Vinyl tubing
1 stainless steel (removable) floor to protect the unit during keg insertion
1 drip tray
Hose clamps
4 casters (“RS” series only)
1 leg shield (“RS” series only)
Various screws
Before Using Your Appliance:
Remove the exterior and interior packing.
Before connecting the unit to a power source, let it stand for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surfaces of the unit with lukewarm water using a soft cloth.
Installing the Kegerator:
Place the unit on a floor that is strong enough to support the appliance when it is fully loaded. To
level the unit, adjust the two leveling legs at the front.
Kegerators that begin “SBC58” or “SBC56” are designed for freestanding or built-in installation.
Kegerators that begin “SBC7RS” are designed for freestanding or recessed installation in a 24-inch
wide (minimum) opening. Please allow 2” clearance in the back and some airflow on the sides and
top of the units. Take care that the air vents at the front of the appliance are never covered or
blocked in any way.
Locate the unit away from direct sunlight and sources of heat (oven, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extremely cold ambient temperatures may also affect the unit's performance.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to form quickly
on the evaporator, requiring more frequent defrosting of the interior.
Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or authorized
service center.
Loading ...
Loading ...
Loading ...