Loading ...
Loading ...
Loading ...
16
B
3FNPUF#BUUFSZ3FQMBDFNFOUCVUUPO
Replace remote battery with a CR2032 coin cell battery.
1. Slide the battery cover o.
2. Slide out the old battery and slide in the new. Be sure positive side (+) is UP.
3. Slide the battery cover on until it snaps into place.
3FNPUF#BUUFSZ3FQMBDFNFOU
CVUUPO
Replace remote battery with a CR2032 coin cell battery.
1. Open remote case using a washer or coin that ts into the slot on the top of the remote.
2. Replace battery.
Be sure positive side (+) is UP.
3. Align components and snap case closed.
1. Disconnect power to opener.
2. Open powerhead lens cover by pressing in on upper locking tab and lower cover.
3. Replace old light bulbs with 100 Watt MAXIMUM incandescent, CFL or LED equivalent**.
* Genie LED light bulbs, which are specically made for garage door openers, are recommended.
4. Close lens cover.
5. Reconnect power to door opener.
6. Test light operation.
NOTE: Use of standard LED bulbs may reduce the
range of your remote controls*.
WARNING
!
tUse extreme caution when working from a ladder or step
stool or serious injury can occur.
tWhen replacing light cover, make sure wires are not pinched
or near moving parts.
tUse only properly rated incandescent, LED or CFL light bulbs.
tDO NOT use bulbs with a rating greater than 100 Watts.
tUse A19 size light bulbs. DO NOT use bulbs having a short
neck.
AVERTISSEMENT
!
tFaire particulièrement attention lors de travaux eectués
depuis une échelle ou en escabeau.
tEn referment le couvercle de l’éclairage, s’assurer que les ls
ne sont ni coincés ni près des pièces mobiles.
tUtilisez uniquement incandescence correctement classé, LED
ou des ampoules uocompactes.
tNE PAS utiliser des ampoules avec une note supérieure à 100
Watts
tUtilisez A19 ampoules de taille. NE PAS utiliser des ampoules
ayant un cou court.
(FOJF-&%MJHIUCVMCTBSF
EFTJHOFEUPSFEVDFPSFMJNJOBUF
SFEVDFESFNPUFSBOHFJTTVFT
DBVTFECZDPNNPO-&%CVMCT
5IFZBMTPPòFSCFUUFSQSPEVDU
MJGFCZNBLJOHUIFNSFTJTUBOU
UPWJCSBUJPODBVTFECZUIF
PQFOFSBOEDPMEPSEBNQ
XFBUIFS4FFXFCTJUFGPSEFUBJMT
BUXXXHFOJFDPNQBOZDPN
SFDPNNFOEBUJPOTGPS-&%CVMCT
**Integrated Aladdin Connect® models require a .*/*.6. 40 Watt or equivalent
bulb, 100 watt maximum.
Models equipped with Integrated LED lighting require specialty kits available for
order in the parts section. See page 24.
C
Replacing Batteries
Changing Light Bulbs (Genie LED bulbs recommended)
Loading ...
Loading ...
Loading ...