Loading ...
Loading ...
Loading ...
3.6 GAS APPLIANCE INSTALLATION
1. Leave at least 80 to 85cm between the top of
the gas appliance and any cabinet or appliance
hood installed above or to be installed .
2. Leave at least 5cm in the back and 2cm each
side of the gas appliance to allow the heat to get
out.
3. When installing the oven, be sure not to block
the oven exhaust port.
4. After installation,please paste the rating label
on visible location or nearby.
3.7 ELECTRICAL CONNECTION
5cm
Only a licensed professional may connect the appliance.The appliance must be
installed according to the most recent AGA and SAA regulations.The appliance could
become damaged if incorrectly connected.Make sure the voltage of the power
supply corresponds to the specified value on the rating plate. The rating plate can be
found on the inside of the storage compartment flap.Ensure that the power supply is
properly earthed and that the fuse and the wiring and piping system in the building
can withstand the load from the appliance. It is recommended that you configure the
circuit for the appliance to 16 A. When you route the mains cable, make sure that:
the cable is not trapped or squashed;
the cable does not come into contact with sharp edges or cutting edges;
the cable does not come into contact with parts that can reach temperatures of more
than 50 °C above room temperature.
3.8 CONNECTING THE MAINS CABLE
Where the appliance is directly connected to the power supply, an all-pole isolating
switch with a contact gap is required.Complete disconnection in compliance with the
conditions specified in overvoltage category III must be guaranteed.The earth cable
is excluded from this.
P a g e |
13
ONLINE: TRINITYAPPLIANCES.COM.AU
80 to85 cm
Loading ...
Loading ...
Loading ...