Loading ...
Loading ...
Loading ...
-16-
ENSURE POWER IS SWITCHED OFF BEFORE SERVICING.
All servicing should be carrier out by a competent electrical serviceman.
TROUBLE SHOOTING
FAULT CAUSE REMEDY
Motor/Pump will not operate (no
motor/pump noise).
No power to unit.
Motor overload protection has
tripped.
Check supply cord connection.
Check power supply is on.
Check power is available at
supply.
Remove access plug from L/H
side panel and reset overload
switch (depress).
Motor/Pump will not operate
(motor/pump makes noise but will
not pump oil/shortening).
Motor / Pump stalled.
Blockage in pump or delivery
system.
Switch off then switch on again
either in forward or reverse
direction.
Refer operating instructions -
“Important points to remember”
page 12.
If unable to free blockage contact
an authorised service company.
All other faults refer to an authorised service company.
Loading ...
Loading ...
Loading ...