Loading ...
Loading ...
Loading ...
-11-
6. Unwind electrical supply cord of Filtamax filter from around cord hanger and plug into correct
electrical supply. Ensure filter control switch is in the “Off“ position before turning electrical supply
on.
7. Switch on electrical supply.
8. Push Filtamax filter unit back into cabinet so that the filter bag drain guard is positioned over the
drain valve of the fryer.
9. Position the return tube over the nose rail of the fryer so that the outlet is positioned towards the
inside of the fryer tank.
10. The fryer is now ready for filtering.
11. Release the safety catch on the fryer drain valve and slowly open the valve. Drain entire contents
of fryer tank into the filter unit.
12. When contents of fryer have been drained into filter unit, remove the sediment tray from the fryer
tank for separate cleaning.
13. Holding the return tube insulated handle with one hand, set the filter pump switch to the forward
position. The filter will now start pumping the oil from the filter tank back into the fryer tank.
14. With the drain valve still open the returning oil can now be used to wash down sediment from
around the tank sides out the drain and into the filter bag.
To get at all the sediment on the tank insides it may be necessary to use a scrubbing brush to
assist with the oil washing down.
15. When the inside of the fryer tank has been suitably washed out, set the filter pump switch back to
the “off” position and close the fryer drain valve.
16. The filtered oil can now be returned back to the fryer tank. With the drain valve still closed, set the
filter pump switch to the “forward” position again and pump the oil back into the fryer tank.
17. When oil ceases to exit from the return tube and the pump appears to be pumping air only, set the
filter pump switch back to the “off” position.
18. Lifting away the return tube by the insulated handle carefully pull the filter unit out from under the
fryer until the filter unit is clear.
19. Remove the filter bag and frame from the filter unit.
20. Place the return tube back into it’s storage position.
21. The filter bag sediment contents should now be discarded. The filter bag itself once emptied of
the sediment should be cleaned by washing out in hot water only. It is not necessary to unclip the
filter bag from the filter bag frame for washing out purposes, although this may be done if desired.
22. With the return tube back in it’s storage position, set the filter pump switch to the “reverse” setting
to flush out any oil contained in the pump system back into the filter tank.
NOTE: It is necessary to hold the filter pump switch when in the reverse position for approximately
5-10 seconds to effectively flush all the oil from the pump system.
OPERATION
IMPORTANT
Always ensure that the reversing pump flush out procedure is carried out at the
end of a filter operation. If this procedure is not followed, oil or shortening may
solidify in the pump system and cause blockages when next filtering.
Loading ...
Loading ...
Loading ...