Loading ...
Loading ...
Loading ...
13
FIGURE 13
completely below the snap ring groove. Place snap ring
(19) into groove in cord entry bore of housing. Repeat
terminal block installation for control cord, if equipped.
F-4.4) Cord Assemblies:
Power/Control Cord - Refi ll the cooling oil as outlined in
paragraph F-1.3. Make wire connections as outlined in
paragraph F-4.3. Insert female end of cord plug into housing
bore aligning timing mark with hole in terminal block (21), see
Figure 13. Compress cord plug with compression fl ange (16a)
by tightening hex bolts (11) into the housing (6). Torque to 132
in-lbs.
FIGURE 12
FIGURE 14
SINGLE PHASE - 240 VOLT AC (PSC)
Loading ...
Loading ...
Loading ...