Loading ...
Loading ...
Loading ...
_Tips
• Depending on your TV and other equipment you wish to
connect, there are various ways you could connect the
DVD+VCR. Use connections described on pages 11-14.
• Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the best
connections.
• For better sound reproduction, connect the DVD+VGR's
DVD/VHS AUDIO OUT jack to the audio in jacks of your
amplifier, receiver, stereo or audio/video equipment. See
Optional, Preferred TV Connections on page 13-14.
_Caution
• Make sure the DVD+VCR is connected directly to the TV.
Tune the TV to the correct video input channel.
• Do not connect the DVD+VCR's DVD/VHS AUDIO OUT
jack to the phono in jack (record deck) of your audio
system.
• Do not connect your DVD+VCR via your VCR• The DVD
image could be distorted by the copy protection system.
Connecting Antenna/Cable TV to
DVD+VCR
_ Disconnect the antenna leads from the rear of the
TV.
identify the type of cable from your antenna• if it is
a round cable as illustrated, it is a 75 ohm coaxial
antenna cable. This cable will connect directly to
the jack marked ANT.IN on your DVD+VCR.
_Tip
If your antenna lead wire is a fiat type antenna cable,
connect it to a Antenna Adaptor (300-ohm to 75-ohm)
(not supplied) and slip the Adaptor onto the ANT•IN
jack. The Adaptor does not screw on to the DVD+VCR+
it just slips over the jack.
Antenna Antenna
Flat Wire
(300 ohm)
300/75 ohm
OR OR
Adaptor
(Not supplied)
Cable TV
Wall Jack
!
Rear of DVD+VCR
Without Cable Box
If your cable wire is connected to your TV without a converter
or descrembier box, unscrew the wire from your TV and attach
it to the ANT.IN jack on the DVD+VCR. Use the supplied round
coaxial cable to connect between the DVD+VCR's REOUT
jack and the 75 ohm antenna input jack on the TV• With this
connection, you can receive all midband, super band, and
hyperband channels.
With Cable Box
If a converter is required in your cable system, follow the
instruction below:
The cable hookup permits both TV and DVD+VCR operation.
TO view or record CATV channel
1 Tune the TV to the DVD+VCR output channel (CH 3 or 4),
2 Set the DVD+VCR channel selector to the output channel of
the Cable Converter box by pressing the CH/TRK (+/-) or
number (0-9) of your DVD+VCR, (Example: CH3)
3 Select the channel to view at the Cable Converter Box.
_Notes
• With this connection, you CANNOT record one program
while viewing another.
• If you are using a cable box to tune channels, it is not nec-
essary to do Auto Channel Programming(Auto Channel Set)
as indicated on page 16.
Cable TV
Wall Jack
Back Panel of _]
Typical Cable Box L_
)
H
Rear of DVD+VCR
1-13
Loading ...
Loading ...
Loading ...