Loading ...
Loading ...
Loading ...
Hints and Care
{ How to Get the
{\_])j__y Most Out of
Your Energy
Dollar
• When placing refrigerator into final
position, allow for 1" clearance
around the top and sides of unit to
supply ample ventilation for
optimum energy efficiency.
, Avoid overcrowding refrigerator
shelves. This reduces effectivity of
air circulation around food and
causes refrigerator to run longer.
• Avoid adding too much warm food
to unit at one time. This overloads
compartments and slows rate of
cooling.
• Do not use aluminum foil, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less efficiently.
• A freezer that is 2/3full runs most
efficiently.
• Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation,
• Refer to this Use and Care Guide
section on temperature controls for
recommended control settings
• Clean door gaskets every three
months according to this Use and
Care Guide's cleaning instructions.
This will assure that door seals
properly and unit runs efficiently.
• Take time to organize items in
refrigerator to reduce time that door
is open.
• Be sure your doors are closing
securely by leveling unit as
instructed in this Use and Care
Guide.
• Clean condenser coils as indicated
in the Use and Care Guide every 3
months. This will increase energy
efficiency and cooling performance.
How to Remove and Replace Light Bulbs / j,'
I _ WARNING ]
To avoid electricalshock which can cause severe personalinjuryor death
disconnect power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
I _ CAUTION l
To avoid personalinjuryor propertydamage, observe thefollowing:
° Allowlightbulbtocool.
• Wear gloveswhen replacinglightbulb,
#-
Upper refrigerator section
1, Locate finger gaps on each side of clear light
shield, insert fingers and press in on each side
of shield. Pull shield down and remove.
2, Remove light bulbs, O
3. Replace with appliance bulbs no greater than "__
40 watts.
4, Replace light bulb cover by inserting front tabs of /'%' _l
light shield into slots directly in front of light assembly,
ver and pull straight
F .-_ II
no greater than 40 II _ /Iv ii
I 4_bs m)oflightc#_,erintolinerslotsand "_,,..._ _"
Freezer section A
1. Remove ice bin by lifting front of bin and pulling out.
2. pullingRernove,ight bu,b cover by pinching top tab (A) and[__(_coverout, _ _" _
3, Remove light bulb. Replace with appliance bulb
no greater than 40 watts.
4. Insert bottom tab (B) of light cover into liner slots and snap B
top portion over light assembly,
5, Replace ice bin by sliding in until bin locks into place.
}
ice and water dispenser
1, Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2. Replace light bulb with a 7-watt, 120 volt bulb.
20
Loading ...
Loading ...
Loading ...