Loading ...
Loading ...
Loading ...
Limited Edition Control Features
Dispenser Features
o o 0 0 0 0
SENSOR
FILTER DISPENSER FILTERED ICE & WATER UGHT
Dispenser Operation _
To dispense:
Select CUBE, CRUSH, or WATER mode by pushing button on dispenser control panel. A green indicator light above
button shows mode selection.
Press container against dispenser pad. Selection mode may not be changed while ice dispenser is in operation.
NOTE: If water dispenser is continuously active for more than 5 minutes, an automatic lock out sensor will shut down
power to dispenser area. For instructions on how to unlock your dispenser, see the section entitled "Dispenser Lock"
below.
Dispenser Lock _
This feature prevents ice or water from being dispensed. _ |
To lock and unlock dispenser: |
To lock dispenser press and hold LOCK/UNLOCK button for 3 seconds. A green indicator light above button confirms |
dispenser is locked. /
o
Filter Status indicator Light
The filter status indicator light serves as a reminder to replace the water filter. A green light indicates that the
filter is in good condition. A red light indicates the filter should be changed. Once light turns red. it will remain
red until function is reset.
o
O Good
Change
FILTER
To reset indicator:
Press and hold both LOCK/UNLOCK and WATER buttons simultaneously for 4 seconds, The green filter
status indicator light will flash 3 times when the function has successfully reset.
Auto Light _-o,r_
The auto light function offers the ability to activate the dispenser light at half-power when the
MGHT
LIGHT SENSOR detects that the light levels in room are low.
To activate and deactivate auto light:
To activate, press ON/OFF button located on control panel. A green
indicator light above button displays to show that sensor is active. NOTE: Dispenser light will operate whether
or not auto light is selected.
To deactivate, press ON/OFF button. Green indicator light will go out.
Sabbath.ode รท
This mode is intended to deactivate power to the LED and dispenser lights, while allowing the
controls to remain operational.
To activate and deactivate Sabbath Mode:
To activate, press and hold both LOCK/UNLOCK and ON/OFF buttons
simultaneously for 3 to 4 seconds, After 3 to 4 seconds, the LED and dispenser
lights will turn off Dispenser light will not activate during dispensing while in
this mode=
To deactivate, press and hold both LOCK/UNLOCK and ON/OFF buttons simultaneously for
3 to 4 seconds After 3 to 4 seconds, the LED and dispenser lights will activate
15
NOTE: in the event that power is
interrupted while the Sabbath Mode
is active, the control will remain in
Sabbath Mode when power returns.
Loading ...
Loading ...
Loading ...