Loading ...
Loading ...
Loading ...
Before You Call
Solutions to Common Problems
Before you call for service, review' this list. it may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and Displays Electronic control has detected a fault condition. Press STOP/CLEAR
any F code error (e×ampie F11). to clear the display and stop the beeping. Reprogram the oven. if a fault
reoccurs, record the fault number. Press STOP/CLEAR and call Sears or
another qualified servicer.
"d=O" is displayed. The door was left open and controls set for self-cleaning cycle. Close the
Faulty installation.
Range not leveled.
Bad cooking results.
Oven light does not work.
Fan noise during cooking operation.
Entire oven does not operate.
door and push STOP pad,
1- Place oven rack in center of oven.
2- Place a level or a marked glass measuring cup filled with water on the
center of the oven rack.
3- If the water level is uneven, adjust the leveling legs of the unit (refer to the
installation instructions for leveling the range).
4- if the level is still uneven, contact an installing agent to adjust the cabinet
cutout flooring.
Kitchen cabinet misalignment may make oven appear to be not level.
Be sure cabinets are square and level. Contact cabinet maker to correct
problem.
Burned-out or loose bulb. Follow the instructions under Changing Oven
Light to replace or tighten the bulb.
A cooling fan may automatically turn on and off to cool internal parts. This is
normal, and the fan may continue to run even after oven is turned off.
When the oven is first plugged in, or when the power supply to the oven has
been interrupted, the display will flash. The oven cannot be programmed
until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact Sears or another qualified servicer.
Service wiring not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric
company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions under Setting Oven Controls
to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call Sears or another qualified servicer.
!iI...................
...........ii.......
27
Loading ...
Loading ...
Loading ...