Loading ...
Loading ...
Loading ...
7
2 Changing the initial needle position
You can change the stitch selected when the
machine is turned on to either
“straight stitch
(left needle position)” or
“straight stitch (middle
(center) needle position)”� (Default:
)
1
Turn off the machine�
2
Holding down 2, turn on the machine�
3
After the machine has turned on, release 2�
X
The initial needle position is changed�
The currently selected stitch can be confirmed
by the stitch number in the LCD�
3 Turning on/off the operation beep ★
You can turn on/off the operation beep�
(Default: On)
1
Turn off the machine�
2
Holding down 3, turn on the machine�
3
After the machine has turned on, release 3�
X
The operation beep setting is changed�
4 Changing the maximum sewing speed
You can change the maximum sewing speed to
either the standard or slower speed�
(Default: Standard speed mode)
When the slower speed mode is selected, the
maximum speed adjusted with the sewing speed
controller becomes slower� ★
1
Turn off the machine�
2
Holding down 4, turn on the machine�
3
After the machine has turned on, release 4�
X
The maximum sewing speed is changed�
l : Slower speed mode
: Standard speed mode
5 Turning on/off the automatic reverse/
reinforcement stitching
You can set the machine to automatically sew
reverse or reinforcement stitches at the beginning
and end of stitching� (Default: Off)
1
Turn off the machine�
2
Holding down 5, turn on the machine�
3
After the machine has turned on, release 5�
X
The automatic reverse/reinforcement stitching is
turned on or off�
l : On
: Off
*
For details, refer to "Automatic reverse/reinforcement
stitching" (page 17)�
6 Changing the needle mode
You can change the needle mode to either the
single or twin needle mode�
(Default: Single needle mode)
1
Turn off the machine�
2
Holding down 6, turn on the machine�
3
After the machine has turned on, release 6�
X
The needle mode is changed�
: Single needle mode
: Twin needle mode
*
For details, refer to "Sewing with the twin needle" (page
13)�
7 Stitch adjustment ★
With some stitches, a stitch pattern may turn out
poorly depending on the type of fabric� In such a
case, you can make adjustments� (Default: 0)
1
Turn off the machine�
2
Holding down 7, turn on the machine�
3
After the machine has turned on, release 7�
X
The machine turns into the stitch pattern
adjustment mode�
*
For details, refer to "Making Adjustment" (page 23)�
Threading the Machine
Winding/Installing the bobbin
CAUTION
• Make sure the power is off while threading
the machine� If you accidentally step on the
foot controller and the machine starts to sew,
you could be injured�
• Be sure to use the
included bobbins
(part code: SA156,
SFB: XA5539-151) or
the same type�
SA156 is Class 15 type bobbin�
11�5 mm (7/16 inch)
1
Pull up the spool pin as far as
possible, and put a spool of
thread on this pin�
Make sure that the thread
unwinds as shown�
CAUTION
• If the spool of thread is not in the right place,
the thread may tangle on the spool pin�
★
: Only for some models�
Loading ...
Loading ...
Loading ...