Loading ...
Loading ...
Loading ...
MOWER DECK BAFFLE (See Fig. 1)
Use Hardware - - GROUP "A"
• Raise your tractor mower deck to its highest position,
• Install the hex bolt, and lecknut through mower deck
baffle and tighten securely.
HEX BOLT
MOWERDECK BAFFLE
FIG. 1
REAR MOUNTING BRACKET
(See Figs. 2A, 2B & 2C)
NOTE: If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group "B" and disregard the remaining Step 2
instructions.
BOLTS
LANCED TABS
TOWARD BOTTOM
FIG. 2A
Ifyourtractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"
Only one set of hardware in GROUP "B" will be used to
mountthe rear mounting bracket. To determine which set
iscorrect for your tractor, check to see ifthere are (2) two
upper corner ribs on each side of drawbar. If your tractor
has the upper corner ribs, use the (4) four self tapping
shoulder bolts. Ifyourtractor does not have the corner ribs,
use the set of (4) four bolts and Iocknuts.
SELFTAPPING SHOULDER BOLTS (See Fig. 2B)
• Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
Hangthe mounting bracket,lanced tabstowardsbottom,
on the bolts.
_._ UPPER CORNER
UPPER CORNER _-._._'_'_,_ RI#BS
RIBS
SELF I" rr_.
TAPPING I (L ">.._'.,_
SHOULDER_
BOLTS _ I
LANCEDTABS
TOWARD BOTTOM
FIG. 2B
BOLTS AND LOCKNUTS (See Fig. 2C)
IMPORTANT: ONTRACTORSWITH FUELTANKUNDERTHE
SEAT,THE DRAWBAR MUST BE REMOVED FOR INSTALLATION
OF MOUNTING BRACKET.TO REMOVE DRAWBAR, REMOVE
TWO HEX BOLTS ON BOTH SIDES OF DRAWBAR.
• Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller inside holes on the
drawbar.
NOTE: Ifyour tractordrawbar does not have the four correct
holes for mounting the bracket, refer to the PREPARATION
section of this manual.
• Install the four bolts and Iocknuts as shown and tighten
securely.
• If drawbar was removed from tractor, reassemble to
tractor at this time. Tighten securely.
A BOLTS
I /
LOCKNUTS I _L__---,_=_-",-_ _"_-"
,BOT.S,DES,
_.f- - LANCED TABS TOWARD BOTTOM
FIG. 2C
COVER SEAL (See Fig. 3)
No hardware required
• Align mark on seal with mark at cover opening.
• Work seal into opening so cover sits between flanges
of seal.
ALIGNMENT
MARKS
COVERSEAL _ (
8 FIG. 3
Loading ...
Loading ...
Loading ...