Loading ...
Loading ...
Loading ...
PRESS
TOGETHER
TO FORM
SEAL WHILE
LIFTING
TOP HALF
CONTAINER
BOTTOM
HALF
LOCKING
FIG. 6 TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and Check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
CONTAINER MOUNTING
(See Fig. 7)
No hardware required
• Install one container to left side first with warning to
outside of unit. Install other container to right side.
NOTE: Right container shouldalways overlap leftcontainer
at center support.
• Close cover and lock latch handle over center support
tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBE
CONTAINER
WARNING
LOWER CHUTE (See Fig. 8)
Use Hardware - - GROUP "E"
Raise and hold deflector shield in upright position.
Slide back edge of chute over rear corner of mower
deck and pivot forward.
Align slot in lower chute with hex bolt in mower deck
baffle and close chute over deck openning.
Secure with washer and wing nut.
CAUTION: Do not remove discharge
guard from mower. Raise and hold
guard when attaching lower chute
and allow it to rest on chute while in
operation.
DEFLECTOR SHIELD
WASHER
\
MOWER DECK
\
WING NUT HEX BOLT
FIG. 8
CHUTE LATCH ASSEMBLY
(See Fig. 9)
Use Hardware ° - GROUPS "F & G"
• Assemble latch pin to upper chute, as shown.
• Press weld nut into rubber latch and assemble rubber
latch to )ower chute, as shown.
• Tighten all hardware securely.
. \ WASHERS
#10x1-118 SCREW _ 3/16x3/4x16Ga.
\\ ½ SPL,T
_ _'" )_ / SPACER
/ / ACORNNUT
UPPERCHUTE_ _, _ LATC_R
LOWER CHUTE J
/ o\_._LOC_WAS.ERWASHER
3/16 x 3/4 x 16 Ga. o%X
FIG. 9
FIG. 7
10
Loading ...
Loading ...
Loading ...