Loading ...
Loading ...
Loading ...
BEFOREYOU STARTTO ASSEMBLE THE GRASS CATCHER
Some tractor models may need minor modifications before you can mount the grass catcher to the tractor. Lookcare-
fully at the mower deck on your tractor and compare the deck mandrel to the illustrations below. If your mower deck
mandrel looks like STYLE "A", your tractor is ready - proceed with the grass catcher assembly. If your mower deck
mandrel looks like STYLE "B", go to the PREPARATION section in this manual.
DECK MANDREL
STYLE "A"
DECK MANDREL
STYLE "B"
PARTS IDENTIFICATION
COVER
UPPER CHUTE
FULL
BAGGER
INDICATOR
GRASS
CONTAINERS
CHUTE LATCH
LOWER CHUTE
LOWER CHUTE
WING NUT
NOTE: When right hand (R.H.) and left hand (L.H.) are mentioned in this manual, it means when you are seated on the
tractor, in the operator's position.
(1) 3/8" Wrench
THESE ARE THE TOOLS YOU WILL NEED TO AS- (1)_1/2" Wrench
SEMBLE YOUR GRASS CATCHER: (2) 9/16" Wrenches
(1) 1/2" Socket
(1) 9/16" Deep well Socket
(1) Drive Ratchet
(1) 3" or longer Extension
(J) Short Handle
Phillips Screwdriver
A
CAUTION: BEFORE ASSEMBLING GRASS CATCHERTOTRACTOR:
• Depress clutch/brake pedal fully and set parking brake.
Place gearshift/motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key "OFF" and remove key.
• Make sure the blade and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
7
Loading ...
Loading ...
Loading ...