Loading ...
Loading ...
Loading ...
DRILL 4 HOLE BOLT PA'n'ERN
(See Figs. 13,14 & 15)
On some modeltractors, it may be necessary to drill new
holes in drawbar for the mounting bracket. To determine if
you need to drillholes in your drawbar, closely look at the
illustration below.
-C-_ ;I
...... J
11 I-- ii
,,
I _ i t J ,
:,..... ,',; ,:
II
Jl
,,, ..
o*Lxe
FIG. 13
2-1/4"
J
1-7/16"
Your drawbar may or may not have some or all of the holes
shown. Forthe assembly of your new grass catcher only the
five holes dimensioned will be used. If your drawbar does
not have the five holes in the correct positions continue
with this section.
• Remove the drawbar by removing the two mounting
bolts on each side. Keep hardware for remounting.
NOTE: If your tractor has a wire loop mounted to the draw-
bar, remove it at this time.
DRAWBAR
WIRE LOOP
Not on all
models)
• Place the drawbar in a vice or similar locking device.
• Cut out the 4 hole bolt pattern template from the back
of this manual.
• Align toD and r_ of template and drawbar.
• Tape in position.
• Mark and drill hole #1 only, using a 11/32" drillbit.
• Assemble mounting bracket to drilled hole indrawbar
with one hex bolt and nut from hardware group"B=.
NOTE: Mounting bracket must be assembled with lanced
tabs to bottom as shown.
HEX BOLT DRAWBAR
AND NUT
/ L..__ . MOUNTING
/ " B.ACNET
I IO ,'-
I IO " •
h _
Ii
Ii
Ii
II
Ii
t_ .....
LANCED TABS
TO Bo3-rOM
WIRE LOOP
/ MOUNTING
HOLE
(drill 9/32"
if necessary)
_-PARALLEL
FIG. 15
• Align bracket so it is parallel with right edge ofdrawbar
and tighten securely. Holes in bracket should line up
with remaining holes intemplate.
• Using bracket as a template, drill remaining three (3)
11/32" mounting holes.
NOTE: Ifyour tractor isequipped with a wire loop,drillnew
mounting hole as shown, if necessary.
For ease of assembly mounting bracket should be
assembled at this time (refer to "REAR MOU_NTING
BRACKET" in ASSEMBLY section of this manual). "i:
Remount drawbar to tractor using hardware previously
removed.
NOTE: Failure to reconnect the wire loop connection will
result in not being able to start tractor.
FIG. 14
DRAWBAR
MOUNTING
BOLTS
(bothsides)
PROCEED WITH ASSEMBLY INSTRUCTIONS
IN THE FRONT OFTHIS MANUAL
15
Loading ...
Loading ...
Loading ...