Loading ...
Loading ...
Loading ...
page 9
9. Light Kit Assembly (Optional). (cont.)
Connect female plug from switch housing to
male plug from motor housing, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Make sure plugs
connect completely.
Align holes in switch housing with holes in
switch housing plate. To attach switch housing,
re-insert screws that were previously removed.
Securely tighten all 3 screws with a Phillips
screwdriver.
Install 2 medium base 9 watt LED bulbs
(included).
IMPORTANT: When replacing bulbs, please
allow bulbs and glass shade to cool down
before touching.
Remove finial, finial plate, hex nut, spring
washer and rubber washer from threaded rod
on light kit fitter.
Place rubber washer inside glass shade over
center hole. Raise glass shade in order to guide
pull chains through corresponding holes in
glass shade. Align threaded rod on light kit
fitter with hole in middle of glass shade and
push up gently, allowing threaded rod to come
through hole. (Be sure pull chain for fan
operation does not rub against bulb during
operation.) Replace spring washer and secure
glass shade with hex nut that was previously
removed. Do NOT overtighten hex nut as glass
may crack or break.
Thread pull chains through corresponding
holes in finial plate, allowing threaded rod to
come through hole in middle of finial plate, and
push up. Thread center pull chain through hole
in finial and re-attach finial. Do NOT overtighten
finial as glass may crack or break.
bulb
threaded rod
light kit fitter
motor
housing
male plug
female plug
glass
shade
switch housing
plate
switch
housing
finial
finial plate
spring washer
hex nut
rubber
washer
Loading ...
Loading ...
Loading ...