Loading ...
Loading ...
Loading ...
page 8
9. Light Kit Assembly (Optional).
motor housing
switch housing
switch housing plate
male plug
female plug
hex nut
lock washer
light
kit
fitter
cap
switch
housing
light
kit
fitter
switch
housing
molex
connections
WHITE
BLACK
WHITE
BLUE (or BLACK)
hex nut
lock washer
diagram 1
diagram 2
diagram 3
Remove 3 screws from outer edge of switch
housing plate (on underside of motor)--save
screws for later use.
If you wish to use fan WITHOUT the light kit,
connect female plug from switch housing to
male plug from motor housing, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Align holes in
switch housing with holes in switch housing
plate. Re-insert screws that were previously
removed and securely tighten all 3 screws
with a Phillips screwdriver. [Refer to
diagram 1.] Go Section 10 on page 10 to
complete installation without the light kit .
If you wish to use your fan WITH the light
kit, remove hex nut and lock washer from
threaded rod at top of light kit fitter. Punch
center cap out of switch housing with a
screwdriver. [Refer to diagram 2.]
Gently push wires from light kit fitter (one by
one) through hole in middle of switch housing
and screw switch housing onto threaded rod
followed by lock washer and hex nut that
were previously removed. Tighten hex nut
over lock washer for a secure fit. [Refer to
diagram 3.]
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLUE (or
BLACK) wire from switch housing. [Refer to
diagram 3.] Be sure molex connections snap
together securely.
["Light Kit Assembly" continued on next
page.]
Loading ...
Loading ...
Loading ...