Loading ...
Loading ...
Loading ...
page 7
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was
removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy
cover with screwheads in bottom of canopy.
Turn canopy cover to the right (clockwise)
until it stops.
canopy
hanging
bracket
screw
canopy cover
blade arm
blade
blade attachment
screws and washers
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools
to assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in hardware packs. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade
arms). Align blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. [Note: Use
slot located on switch housing plate for
easy access to motor screw holes with
screwdriver.] Before securing screws
permanently, repeat this procedure with
remaining blade arms. Securely tighten all
screws.
IMPORTANT: Tighten blade arm screws
twice a year.
motor
housing
blade arm screws
lock washers
plastic
motor lock
switch
housing
plate
Loading ...
Loading ...
Loading ...