CD67G0C2CJ/UK User Manual

Loading ...

• Pry the fixing tab “V” and remove the oven burner

• Unscrew the oven burner nozzle using the socket

spanner for the nozzles

“Z”“Z”

“Z”, or a 7 mm socket

spanner, and replace it with a nozzle suited to the

new type of gas (see Table 1).

Take particular care handling the spark plug

wires and the thermocouple pipes.

• Replace all the parts, following the steps

described above in the reverse order.

b )b )

b ) Minimum regulation of the main and top gas

oven burner with thermostat:

• light the burner as described in the

paragraph the oven knob” of the

instruction booklet.

• turn the knob to

MaxMax

Max for about 10 minutes

and then turn the knob to the

MinMin

Min

setting;

• remove the knob;

• regulate the screw positioned outside the

thermostat pin until the flame is

small but

steady.

! !

In the case of liquid gas, the regulation screw

must be screwed in to the bottom.

• check that the burner does not turn off

whenwhen

you turn the knob from Max

to Min and and

when you open and close the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

On completion of the operation, replace the old

rating sticker with one indicating the new type of gas

used. This sticker is available from our Service

Centres.

NoteNote

Note

Should the pressure of the gas used be different (or

vary) from the recommended pressure, it is

necessary to fit a suitable pressure regulator onto

the inlet pipe in compliance with current National

Regulations relative to “regulators for channelled

gas”.

If the appliance is connected to a liquid gas supply, the

bypass screw must be set to a minimum.

While the burner is alight, quickly change the position of the

knob from minimum to maximum and vice versa several times,

checking that the flame is not extinguished.

Upon completion of adjustment, reseal using sealing

wax or an equivalent material.

1. Remove the enamelled baffle at the front of the grill

(2 screws).

2. Remove the screw on the right hand side of the

burner and gently slide the burner off the injector.

3. Using a 7mm socket, replace the grill injector as

appropriate (see table on previous page).

4. Re-assemble the burner and baffle.

Adapting to different types of gas (main and top

oven)

In order to adapt the oven to a different type of gas

with respect to the gas for which it was

manufactured (indicated on the label), follow these

simple steps:

a)a)

a) Replacing the oven burner nozzle

• open the oven door fully

• pull out the sliding oven bottom

unscrew the two screws and take off the shield

protecting the burner (in main oven burner only).

�