Loading ...
Loading ...
Loading ...
Changing Oven Light
__'_Be surethe oven isunplugged and all partsare COOLbefore replacing
the oven light. Wear a leather-faced glove for protection against possible broken
glass.
Usethe rocker switch on the control panel to turn the oven light on or off.
To Change the Oven Light (upper oven)
1. Turn electrical power off at the main source or unplug the oven.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug the oven back in).
4. The clock (if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
Adjusting Oven
Temperature
Figure 1: Back of Control Knob
The temperature in the oven hasbeen set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. If you think the oven istoo hot or
too cool, the temperatu re inthe oven can be adjusted. Before adjusting, test a recipe
by using a higher or lower temperature than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
ToAdjust Oven Temperature:
1. Check to be sure the Temperature control knob is in the OFFposition.
2. PullTemperature control knob straight off the shaft.
3. Loosen, but do not remove, the two screws at the back of the knob (Figure 1).
Note: If knob does not have2screws, it isnot adjustable. There isaseriesof small
indicator grooves. One of these grooves ispositioned next to atiny pointer. Note
the position of the pointer.
4. To increase the temperature, move the pointer in a clockwise direction. To
decreasethe temperature, move the pointer in acounterclockwise direction. The
temperature can be adjusted in increments of IO°F.
5. When the desired adjustment is reached, tighten both screws.
6. To replace the knob, line up the flat sides of both the knob and the shaft. Push
the knob into place. DONOTforcetheTemperature Control knob ontothe shaft
or you may damage the back of the knob.
Note: Onceanadjustment ismade,the OFFposition will vary from the reference mark
on the backguard depending on the amount of adjustment.
Loading ...
Loading ...
Loading ...