Loading ...
Loading ...
Loading ...
General Care & Cleaning
Cleaning the Contoured Well Areas, Burner Grates, Burner Caps and Burner Heads
The contoured well areas, burner cap and burner head should be routinely cleaned. Keeping the burner ports clean will
prevent improper ignition and an uneven flame. Refer to the following instructions:
To Clean the Recessed and Contoured Areas of the Cooktop - If a spill occurs
on or in the recessed or contoured areas, blot up spill with an absorbent cloth.
Rinse with a clean, damp cloth and wipe dry.
....Orifice
/j Z
j..--
J
EUectrode
To Remove and Replace the Surface Burner Caps and Surface Burner Heads
- Remove inthe following order: (1st) surface burner grate, (2nd) surface burner
cap, (3rd) surface burner head.
Reverse the procedure above to replace the surface burner cap and surface
burner head. Do not remove any parts from the cooktop until they have
completely cooled and are safe to handle. Do not operate the surface
burners without the surface burner cap and surface burner head properly in
place.
To Clean the Surface Burner Caps, Surface Burner Heads and Burner Grates N1
- Use a soap-filled scouring pad or a mild abrasive cleanser to clean the surface Z
burner caps and surface burner heads. The ports (or slots) around the burner head _,)
must be routinely cleaned. If residue still remains in these ports, use a small- F
gauge wire or needle to clean the slots or holes. For proper flow of gas and
ignition of the burner--DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS Z
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. ALWAYS keep the surface burner cap and surface burner head in
place whenever a surface burner is in use.
Replacing the Oven Door
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside ofthe oven door near the hinges A (one on each side.)
3. Close the door to the quarter-open position. Grasp the doorfirmly on both sides and lift up
and off the hinges.
4. To clean oven door, follow the instructions provided in the General Care & Cleaning table.
///////
//
/ /
j i i
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position. Be careful ifpulling the hinges open
by hand. The hinges may snap back against the oven frame and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at the bottom of the
door.
3. Hinge arms must go intothe range slots evenly. The hinge arms should be inserted into the
bottom corners of the door as far as they can go.
4. Replace the oven door hinge screws (See A in illustration).
5. If the door is not in line with the oven frame, remove it and repeat the above steps.
The door is heavy. For safe, temporary storage, lay the door flat with the inside
of the door facing down.
27
Loading ...
Loading ...
Loading ...